For detailed information, other images and documents, please select individual articles from the following table.
Gypsum-based filler PERFECT FINISH
Ideal for creating a thin skim or thin layer of filler
Register now and access more than 125,000 products
Variants
Register now and access more than 125,000 products
- High filling power, ideal for sealing holes and cracks
- Excellent processability
- High level of whiteness
- Good adhesion after curing
- Easy to sand
- Apply the product at temperatures between 10 °C and 35 °C
- Do not apply PERFECT FINISH in environments with permanently high humidity
- Do not apply PERFECT FINISH to damp or dehumidifying plaster, or to plaster subject to capillary rising damp
- Adverse environmental conditions (wind, extreme cold, extreme heat) can affect the product setting time
- Do not add water to the product once it has started to cure
- Avoid application in strong winds or direct sunlight
- This product is intended for indoor use only
- Do not mix with other substances or materials
- This product is intended for professional use
The instructions for use are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage/usage conditions. Any technical information or advice provided by our free customer service shall be provided to the exclusion of any liability, unless the advice or information is part of our contractually agreed scope of services or the advisor was acting wilfully. We ensure the consistent quality of our products. We reserve the right to make technical changes and further develop products
For preparing internal walls before painting
Suitable for gypsum plasterboard walls, for both filling and skimming
Suitable for:
- Filling screw holes
- Filling joints
- Bonding panels
- Fitting edge protectors
- Filling concrete and plaster surfaces
- Mix the product to a ratio of approximately 65 % clean water
- To prepare correctly, slowly pour the filler into a container of water until the powder is above the water level (e.g. 1 litre of water per 1.5 kg of filler)
- Leave to stand for about 2 minutes, then mix vigorously with a trowel until smooth and lump-free
- The product should be used within 60 minutes of preparation, without adding more water
- Make sure that surfaces are firm and free of dust, oil and grease before application
- Once cured, the product has good adhesion and is easy to sand
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!